This content originally appeared on flaviocopes.com and was authored by flaviocopes.com
In this post I will show you how to build a LED dimmer with a potentiometer.
You need 4 things: a potentiometer, like this 10kΩ one:
A 5mm LED, any color you like:
A breadboard, where we put our components on:
And a battery. I use a 9V battery:
Plus some wires.
Start by putting the potentiometer on the board, in any place you want, with the 2 input pins on one side of the board, and 1 output pin on the other side:
Press it down to connect it to the breadboard:
Now connect the - pin to the blue line of the breadboard which we’ll connect to the negative pole of the battery, and the + pin to red line which we’ll later connect to the + pole of the 9V battery.
I use for convention a black wire for the - (GND) and a red wire for the positive +.
Make sure the potentiometer is completely turned to the left, counterclockwise.
Now connect a LED to the output pin, put the longest wire of the LED, the anode, on the same row. Then connect the cathode, the shortest wire, to the - blue line of the breadboard:
Great, now connect a 9V battery and you’ll see the LED still turned OFF (assuming you turned the potentiometer all the way to the left, counterclockwise, which acts as a 10kΩ resistance in the example).
Be careful not to turn the potentiometer all the way to the right, or the LED could be damaged as the current will be too much to handle.
Rotate it slightly to the right and you’ll start see the light turning on, more and more intense as you turn the resistance down.
This content originally appeared on flaviocopes.com and was authored by flaviocopes.com
flaviocopes.com | Sciencx (2021-03-20T05:00:00+00:00) Electronic Project: Build a LED dimmer with a potentiometer. Retrieved from https://www.scien.cx/2021/03/20/electronic-project-build-a-led-dimmer-with-a-potentiometer/
Please log in to upload a file.
There are no updates yet.
Click the Upload button above to add an update.